Garage door repair in Bloomfield Hills and Oakland County, 7 AM to 10 PMCall the office: (248) 587-8430

Garage Door Spring Repair

Springs sized to your door's weight — across Bloomfield Hills, Birmingham, West Bloomfield, Troy, Franklin, Beverly Hills, Rochester Hills, Orchard Lake Village.

A broken garage door spring has to be replaced with a spring sized for that particular door, because the spring is the part that holds the door's weight. Most residential doors use one or two torsion springs on a shaft above the opening, and some use extension springs that stretch along the horizontal tracks with a containment cable through them. Either type stores energy as the door closes and gives it back as the door rises, so when one breaks the door feels as heavy as it truly is and the opener cannot lift it.

We record the wire gauge, coil length and inside diameter, put the door on a scale, pick the spring that balances it and wind it to the turns the door maker specifies, since too few turns let the door drift down and too many overload the shaft and cables. On a door with two springs we replace both, because they have run the same cycles; a cycle is one trip from closed to open and back. Standard springs are commonly rated around 10,000 cycles, and higher-cycle springs are available for busy doors.

Telltale Signs of a Broken Spring

  • Something snaps in the garage and the door will no longer rise
  • A visible gap in one of the coils above the door
  • The door rises a few inches and sinks back down
  • The opener strains, hums or quits partway up
  • The door feels twice as heavy when lifted by hand
  • Coils covered in orange rust or bone dry to the touch

❄️ The Oakland County Freeze-Thaw Factor

Road salt and meltwater are hard on spring steel. DASMA's data sheet on spring cycle life explains that rust shrinks the working cross-section of the wire and leaves corrosion pits where fatigue cracks start and spread, and it asks for lubrication as the maker specifies. With about 135 days a year at or below 32°F in this part of Oakland County (NOAA 1991–2020 normals), a tired spring in our experience often lets go on the first hard-freeze morning.

We fit coated springs, lubricate them at installation and size them from the weighed door, because an insulated replacement door is heavier than the builder door it replaced.

How We Handle It

Step 1

Weigh and measure

Door weight, wire size, spring length and inside diameter are measured, so the spring is chosen from your door and not from a chart.

Step 2

Quote on site

You get the exact price for the correct spring set before anything is unwound.

Step 3

Wind to the specified turns

Each spring is wound to the door maker's specified turns, lubricated, and the drums and set screws are re-tightened.

Step 4

Hold test at halfway

With the opener disconnected the door should stay where you leave it at 3 to 4 feet; only then do we reconnect and run full cycles.

Technician on a stepladder hanging new track while fresh door sections lie on the floorTechnician on a ladder fastening the header bracket above a white windowed garage door

Spring Replacement Starting Prices

Garage Door Spring Replacement per spring
From $150
Diagnostic Service Call $0 with a completed repair
$0

Prices are per spring; when a door uses two, we usually recommend changing both so they wear evenly, and the choice is yours.

Garage Door Spring Repair — FAQs

What does Belle charge for a new spring?
Springs run from $150 per spring, and the exact quote on site before any work starts gives the real number for your door. The final figure depends on the door's weight, the spring's wire size and length, and whether the door has one spring or two. We name the parts and the price on site, and nothing begins until you agree.
Do both springs need replacing when only one breaks?
On a door with two springs, replace both. Both have flexed the same number of times, so the survivor is already near its limit, and one fresh spring beside a tired one pulls the door out of balance.
Why do garage door springs break in winter?
Garage door springs break from metal fatigue, and winter often exposes springs that were already near the end of their cycle life. Every trip up and down flexes the wire, and rust pits from salt and moisture are where cracks start, as the DASMA data sheet on spring cycle life explains. In our experience the snap often comes on a cold morning, but a healthy spring usually survives the cold.
Is it safe to lift the door myself after a spring breaks?
No. The DASMA inspection checklist tells owners to leave a door with a broken spring unused until the spring is replaced. Without its spring, the door's whole weight falls on the cables, the tracks and whoever is holding it. Disconnect the opener at the red release handle, leave the door where it is and call us; emergency calls are answered 7 AM to 10 PM.
How long do garage door springs last?
Plan on years rather than decades. Everyday torsion springs are often sold with a rating near 10,000 cycles, counting each closed-open-closed trip as one, so a busy household can use up a rating sooner than expected. Higher-cycle springs exist for doors that work harder.
Contact

Talk to the Belle Team

Phone us from 7 AM to 10 PM, or leave your details and a quick description of the problem and we will call back to set a time.

☎ Call (248) 587-8430 Open in Google Maps

Request a call back

Your details are used only to answer your request. Privacy Policy.

☎