Garage door repair in Bloomfield Hills and Oakland County, 7 AM to 10 PMCall the office: (248) 587-8430

Garage Door Cable Repair

Lift cables, drums and bottom brackets — across Bloomfield Hills, Birmingham, West Bloomfield, Troy, Franklin, Beverly Hills, Rochester Hills, Orchard Lake Village.

A garage door lift cable is the steel rope that raises the door as the spring turns the drum, and a cable repair means replacing the rope and checking the drum and bracket it runs between. On a torsion door one cable runs from each bottom corner bracket up to a grooved drum on the shaft; the spring turns the drum, the drum winds the cable, and the cable lifts the door. If one side snaps the door hangs crooked and jams in the track, and a cable that has slipped off its drum leaves the door cocked in its tracks.

We replace both cables together, because the unbroken one has worked the same cycles, and we inspect the drums, set screws and bottom brackets for the wear that frays cables. After resetting spring tension and drum position, the door must lift level and stay put halfway up. Please do not run the opener on a door with a loose cable; it can twist the door in the tracks.

What a Failing Cable Looks Like

  • The door sits crooked, one corner noticeably lower
  • A cable sags in a loop or dangles beside the door
  • The door lifts a few inches and tilts in the track
  • Frayed strands or rust where the cable meets the bottom bracket
  • A cable that has jumped off the drum above the door
  • A sharp snap, then a door that will not move straight

❄️ The Oakland County Freeze-Thaw Factor

Cables fail from the bottom up in this region. Melt from road salt pools at the bottom corner brackets, and the galvanized strands rust where the cable ends clamp to the bracket. The county road commission has said it uses about 64,000 tons of salt in an average winter (WXYZ, 2020), and an unheated garage keeps the damp in place for weeks. In our experience the strands fray first where the rust sits.

We look at the bottom brackets first and replace corroded ones along with the cables.

How We Handle It

Step 1

Secure the door

The door is held in place and the spring tension is released safely, so no side can drop while the old cable comes off.

Step 2

Read the wear

Drums, set screws, bottom brackets and the other cable are inspected, because the cause of one failure sits on both sides.

Step 3

Quote cable and parts

The exact price is given on site for new cables plus any drum or bracket that has worn.

Step 4

Re-tension and level

Both cables go on, the drums are re-seated and the spring tension reset until the door rises level and holds at halfway.

Two technicians on ladders setting the horizontal tracks of a garage doorTechnician standing in a garage beneath a raised wood-grain garage door

Cable Replacement Starting Price

Garage Door Cable Replacement per cable
From $150
Diagnostic Service Call $0 with a completed repair
$0

Priced per cable; because both cables age in the same winter salt, most customers choose to replace the two together once they see them.

Garage Door Cable Repair — FAQs

What does Belle charge to replace a lift cable?
Cables run from $150 per cable, and the exact quote on site before any work starts gives the real number. The final figure depends on the door's size and weight, whether the drums or bottom brackets need replacing, and whether the snapping cable damaged anything else. We list each part and its price on site.
What happens if a lift cable lets go?
When a lift cable snaps, that side of the door loses its support, so the door tilts or jams in the track and the loose cable can tangle on the shaft. Stop using the door, keep people clear and do not run the opener. The repair involves spring tension, so it is a job for a trained technician.
Why does a garage door cable keep coming off the drum?
A cable that keeps jumping off its drum has usually lost tension, sits on a worn or misaligned drum, or the door has shifted in the track so one side lifts more than the other. Re-winding without finding the cause lets it happen again. We check spring tension, drum position and track alignment, then seat the cable in its groove.
Should both lift cables be replaced at once?
Yes. Both cables share the same wear, so replacing only one invites the second to fail and leaves the door unevenly set. We replace both and check the drums.
Can the opener be used while a lift cable is slack?
No. A slack cable lets one side of the door lag behind the other, and the opener will drive the door crooked into the tracks, bend the sections and may pull the rollers out. Disconnect the opener with the red release handle and call.
Contact

Talk to the Belle Team

Phone us from 7 AM to 10 PM, or leave your details and a quick description of the problem and we will call back to set a time.

☎ Call (248) 587-8430 Open in Google Maps

Request a call back

Your details are used only to answer your request. Privacy Policy.

☎